Ok, so I got a bit ahead of myself showing both cans on in the last pics, but that was just to show the mounting hardware. As previously mentioned, I test fit everything before finally locking it all down, and in this pic, you can see that after I put the mounting hardware on each side, I then added what I'm calling the "mid section" pipe, and the right side can/pipe. I found it helped to fit the right can onto the mid pipe first (with both off the bike), then slip the mid pipe into place (with right can attached) and further adjust the right can once in place to line up the bolt holes. Note the big Zard sticker on the can. At first I thought it might hurt the carbon fiber to yank that metal plate/sticker combo off, but after the first ride, the glue warmed right up and was practically falling off. Didn't even leave a mark. Nothing against Zard, but I prefer sticker free.
